Set up instructions for dunk tanks built after April 2015
Dunk Tank Setup Instructions:
1. Find a flat and dirt free area that will allow water to drain into a trouble free zone.
2. Lay out the 9 tank connectors as seen in the picture.
3. The 4 connectors on the center line sit on the ground and the 4 main panels slot onto these connectors.
4. All 4 main base panels come together. Only 1 panel is left to connect. Note the unique back panel has two holes in the top of it for the seat assembly. Make sure this (aft) panel is located in the back of the set and farthest away from the ball thrower.
5. Install the blue tub liner by wrapping the nylon and Velcro strap around the top horizontal frame. The plastic viewing window must face the ball thrower.
6. Slot the seat into the back panel.
7. Instal into the frame on the back right hand side of frame the largest connector that holds the paddle and back drop assemblies.
8. Slide the horizontal paddle assembly through the circle connector that was installed in the prior step 7. Make sure the paddle is in a vertical (upright) position as it is slid into the seat assembly mechanism.
9. Slot both upper panels onto the main frame. The panels must be placed in the front and right side of dunk tank as viewed from the ball throwers perspective. Use the remaining single connector to connect the 2 upper panels together.
10. Sleeve the vertical back drop pole into paddle assembly support bracket.
11. The final step is to sleeve the yellow back stop onto the back drop pole.
12. Your dunk tank should look like this when finished.